Memotec CX950, Hardware Reference Manual, Page: 9 / 182

CONFORMITY MARKINGS FOR EUROPEAN
UNION (EU) DIRECTIVES AND NATIONAL
REQUIREMENTS
Several or all of the following markings may be located on CX950 products.
This marking on the chassis identifies the CX950 as fully compliant with the
requirements of the European Low Voltage (safety) Directive (or LVD), number 73/
23/EEC and the European EMC Directive, number 89/336/EEC (and amendments
that apply to both directives).
This marking on the chassis identifies the CX950 chassis as fully compliant with the
requirements of the European Telecommunication Terminal Directive, number 91/
263/EEC (and amendments) and continued compliance with the LVD and EMC
Directives mentioned above. The approved interfaces are E1 (120 Ohms) (including
T1/E1 I/O and ATM I/O), X.21, V.24 (including Multi I/O), V.35EU, Universal I/O,
DIM I/O (E1), BRI-DV, Analog Voice I/O, DAV I/O and ISDN-S/T I/O.
This marking identifies certain interfaces in the CX950 that are not approved for
connection to PTO-provided networks. Such interfaces are for private or internal use
only, e.g., CX950 console port.
This marking identifies the boards in the CX950 chassis that have interfaces approved
for connection to UK telecommunications networks. The approved interface is E1 (75
Ohms) (including T1/E1 I/O, DIM I/O (with adaptors), and ATM I/O).
This marking on the chassis identifies the CX950 as fully compliant with the
requirements of all applicable ACA Telecommunications standards. The approved
interfaces are E1 (ATM I/O and DIM I/O), ISDN S/T, DAV I/O (FXO), and Analog
Voice (FXO). The E1(T1/E1 I/O) is for behind PBX use only (not approved for direct
connection to the telecommunication network).
This marking on the chassis identifies the CX950 as fully compliant with applicable
Australian EMC requirements.