Memorex RF Optical Mouse, User Manual, Page: 5 / 6

•
To completely charge the batteries allow the mouse to remain
connected to the power supply for a minimum of 8 hours. When fully
charged the batteries will last approximately 3 days.
3) Set the receiver channel switch (located on the bottom side of the receiver) to
the same channel selected in step 1.
4) Connect the receiver to your computers mouse port (either via the USB
connector and available USB port or by applying the USB- PS/2 adapter and
inserting it into the PS/2 mouse port). The green LED indicator should
illuminate.
5) Press the ID Link button (located on the bottom of the receiver). The green
LED light should begin to flash slowly.
6) Press the ID Link button (located on the bottom of the mouse). The green
LED indicator should begin to flash rapidly.
7) Once the frequency is set, the green LED light will remain steadily lit.
•
When the mouse is in motion the green LED light will flash rapidly.
Software Installation:
You will need to uninstall any existing mice drivers or applications prior to installing
the Memorex RF Wireless Optical Mouse software.
1) Insert the driver diskette into your computers floppy drive.
2) Browse the computer and select the computers floppy drive.
3) Explore the floppy diskette
4) Double-click the Setup.exe file
5) Follow the on-screen instructions.
•
Once installation is complete, you will notice a new icon in the system
tray of your computer (lower right hand corner). Double-click this
icon to launch the “Mouse Control Panel”.
Additional Notes:
1) When the batteries have either low or no power, the scroll button will
illuminate. To assure proper mouse functionality, you will need to either
charge or change your batteries when this occurs.
2) When the mouse is charging, the scroll wheel will illuminate red and blink
quickly. Once the charge is near complete, the light will remain steady.
3) The Memorex RF Wireless Optical Mouse comes equipped to conserve
battery life. The mouse will enter “Sleep” mode after 90+ seconds of