DISASSEMBLY INSTRUCTIONS
2-5: CASSETTE SIDE L (Refer to Fig. 2-5)
1. Unlock the 2 supports
1
.
2. Remove the Cassette Side L.
3. Remove the Pack Spring.
4. Remove the Locker Spring.
5. Unlock the support
2
.
6. Remove the Locker L.
Locker Spring
Locker L
Pack Spring
Cassette Side L
Cassette Holder Ass'y
2
Fig. 2-5
2-6: BRAKE BRACKET (Refer to Fig. 2-6)
1.
2.
3.
4.
5.
6.
7.
Remove the Main Brake Spring, S-S Brake Spring,
Joint Arm Spring and T-S Brake Spring.
Remove the 2 screws
1
.
Remove the screw
2
.
Remove the Brake Bracket.
Remove the Sub Brake S, Sub Brake T and Main Brake
T Ass'y.
Remove the Joint Arm.
Remove the Reflector LED 2.
Main Brake Spring
Main Brake T Ass'y
S-S Brake Spring
Sub Brake S
Joint Arm
Joint Arm Spring
Sub Brake T
Fig. 2-6
T-S Brake Spring
2
2-7: TENSION BAND (Refer to Fig. 2-7)
1. Remove the Tension Arm Spring 1.
2. Remove the Tension Arm Spring 2.
3. Remove the Tension Adjust.
4. Remove the Tension Arm Ass'y.
5. Remove the Tension Band Ass'y.
6. Remove the Tension Lever 2 Ass'y.
Tension Arm Ass'y
Tension Lever 2 Ass'y
Tension Arm Spring 1
Tension Band Ass'y
(A)
Fig. 2-7
Tension Arm Spring 2
NOTE
1.
2.
Install the Tension Band Ass'y without twisting it.
Turbine Oil (Lubricating Grade #150) the area marked
with A in Fig. 2-7.
EX: KYOUDO Oil Sulaidasu #150
IDEMITSU Oil Super Multi #150
2-8: REEL DISK (Refer to Fig. 2-8)
1. Remove the Reel Disk S and Reel Disk T.
2. Remove the 2 polyslider washers.
NOTES
1.
2.
3.
4.
5.
6.
Installation of Reel Disk after performing step 1, 2 and 3 in
section 2-7 of DISASSEMBLY INSTRUCTIONS.
The Height Adjustment washers are sometimes
attached to the back of the Reel Disk.
Clean the Reel Disk Shaft and put in height adjusting
washers.
Be careful not to damage the Tension Band Ass'y at the
time of removal and installation.
Be careful not to scratch the Reel Disk Shaft with the
polyslider washer or the tool at the time of removal and
installation.
After oiling (Lubricating Grade #150) the Reel Disk Shaft,
install the new Reel Disk S and Reel Disk T again.
EX: KYOUDO Oil Sulaidasu #150
IDEMITSU Oil Super Multi #150
7.
8.
After installation, adjust the height of the Reel Disk.
(Refer to item 1-1 of MECHANICAL ADJUSTMENTS)
After installation, adjust and confirm the tension post position.
(Refer to item 1-2 of MECHANICAL ADJUSTMENTS)
Brake Bracket
1
1
Reflector LED 2
1
1
Tension Adjust
B2-2
