9
INSERTING AN iPod
Pull the iPod compartment forward by
pressing downward gently on the
groove (A). Remove the iPod
Compartment cover by pulling it
upward gently.
NOTE:
To replace the iPod
Compartment cover, simply align the
pins (B) on the bottom right and left
corners of the cover into the
corresponding holes on the
compartment.
(A)
(B)
(B)
1
Locate the correct iPod dock to use as
shown on pages 21-22. Insert the
dock (A) into the iPod compartment
(as shown), making sure the dock’s
two tabs are facing front, and slip the
tabs into place.
(A)
2
Insert the iPod (A) onto the connector
(as shown). Gently push down so the
connector on the iPod slides onto the
connector on this unit. Push the iPod
compartment back in gently.
(A)
3
If this unit is turned off, once you
connect the iPod, it will start charging
the battery until it is full. If the unit is
turned on and in any other mode, once
the iPod is connected, this unit will
change to iPod mode automatically.
Then, if you disconnect the iPod, this
unit will revert back to the mode that it
was previously in. When the iPod is
connected to this unit, it will be in the
Pause mode.
4
PLEASE SEE NOTES ON THE NEXT PAGE
