8
NOTE!
At low yarn tensions it is possible that no yarn
will be fed out.
►
Move the stationary piece of yarn away from the wind-
ing reel as shown.
The unit will then wind the yarn onto the winding reel.
Operation
Switching on
►
Press the ON/OFF button (3) once.
The unit will check if there are enough yarn windings on
the winding reel. If there are not enough, the missing wind-
ings will be wound onto the winding reel automatically.
The red LED (1) lights up during this function.
When the unit is ready for operation, the green LED (2)
lights up.
Switching off
►
Press and hold down the ON/OFF button for at least
two seconds.
The green LED will switch off.
Threading
►
Insert the threading needle (5) through the ceramic
eyelet (8) on the winding plate (7) until the threading
needle comes out through the inlet eyelet (6).
►
Pull the yarn (4) through the unit using the threading
needle.
►
Push the threading needle from below through the
tensioner (11) until you can see the threading needle
between the winding reel (9) and the tension cone
(10).
►
Pull the yarn (4) through the unit using the threading
needle.
►
Press the ON/OFF button (3).
The unit will automatically wind the yarn onto the wind-
ing reel.
i
MSF 3
