5
4
Mounting option
Lid (optional accessory)
DELIVERY, TRANSPORT AND SETTING UP
Setting up
If the appliance is set up on an uneven surface, it can fall over and injure
you or other people. Always place the appliance on an even, load-bear-
ing and non-slip surface.
CAUTION
The distance between the wall and the rear of the appliance must be at least 15 cm.
The clearance from the ceiling must not be less than 75 cm and the side clearance
from walls or nearby appliances must not be less than 10 cm. Sufficient air circulation
in the vicinity of the appliance must be guaranteed at all times.
Putting into operation
The first time the appliance is operated, it must not be left unattended until it has
reached the steady state.
For connection, please observe the national regulations. Observe the connection and
power ratings (see nameplate and technical data). Make sure to establish a safe PE
conductor connection.
Place the power cable so that
X
it does not represent a trip hazard
X
it cannot come into contact with any hot parts
X
it is easily accessible at all times and can be pulled off quickly, for example in
case of interference or an emergency
You may get your hands or feet squashed when transporting and install-
ing the appliance. Wear protective gloves and safety boots. Only grasp
the appliance below on the sides between the mounted adjustable feet.
CAUTION
The appliance could fall over and injure you. If a lid is mounted, do not
transport the appliance while it is open. Never tilt the appliance and only
transport it empty and in upright position.
CAUTION
NOTICE
Condensation in the electrical components may cause short circuits.
After transporting or storing the device under humid conditions, remove
it from its packaging and let it ventilate for at least 24 hours in normal
environmental conditions. Do not connect the device to the mains pow-
er during this time.
WARNING
CAUTION
Because of the heavy weight of the appliance, you could injure your-
self if you try to lift it. Observe the required number of people to carry
equipment.
< 50 L
50 L
The surfaces of the appliance can overheat during operation and over-
heat heat-sensitive surfaces in close proximity to the appliance. Always
place the appliance on a heat-resistant surface and maintain the spec-
ified clearance around the appliance.
CAUTION
