Installation manual
M-WRG-II ventilation units
- 42 -
Meltem Wärmerückgewinnung GmbH & Co. KG
Am Hartholz 4 · D-82239 Alling
[email protected] · www.meltem.com
VENTILATION THE RIGHT WAY
V E N T I L A T I O N & H E A T R E C O V E R Y
11.10 Attaching the unit cover pull-out straps (for U
2
integrated into wall
installation only)
►
Take the two unit cover pull-out
straps (item 1 in Fig. 50) from the
U
2
adapter kit.
► Remove the protective films from the
glue dots on the straps.
►
Stick the straps to the tops of the unit
cover retainer (item 2 in Fig. 50).
►
Make sure that the straps are
hanging down.
NOTICE
The unit cover pull-out straps will make
it easier to lift off the unit’s cover at a
later date, e.g. to change the air filters.
11.11 Attaching the unit cover to the ventilation unit
►
Hold the ventilation unit cover with
both hands and tilt the top edge of
the cover towards the ventilation unit.
►
Insert the tabs (item 1 in Fig. 51) of
the unit cover into the openings on
the top of the ventilation unit.
►
Lightly press the bottom edge of the
cover against the ventilation unit until
you hear the cover snap in place.
NOTICE
For U
2
integrated into wall installation,
make sure that the unit cover pull-out
straps (item 1 in Fig. 50 on page 42)
are hanging down beneath the unit
cover.
Fig. 50: Sticking on the unit cover pull-out straps
1
1
2
2
Fig. 51: Attaching the unit cover to the ventilation unit
1
1
1
1
