Installation manual
M-WRG-S...
- 6 -
Meltem Wärmerückgewinnung GmbH & Co. KG
Am Hartholz 4 · D-82239 Alling
[email protected] · www.meltem.com
VENTILATION THE RIGHT WAY
V E N T I L AT I O N & H E AT R E C O V E R Y
1.3
Target group
The activities described in this manual must only be carried out by technicians with the following
qualifications:
—
Training in the installation and commissioning of electrical devices
—
Training in electrical hazards and the local safety requirements
—
Knowledge of the relevant standards and directives
—
Knowledge and observance of this document and all the safety instructions
1.4
EU declaration of conformity
The ventilation units
Type:
M-WRG-S...
Part number:
5010
5013
5014-...
5016-...
manufactured by
Meltem Wärmerückgewinnung GmbH & Co. KG
Am Hartholz 4
82239 Alling
conform to the regulations and standards listed in the EU Declaration of Conformity provided.
1.5
National technical approval (for Germany)
A valid national technical approval from the
Deutsches Institut für Bautechnik (DIBt) must be
obtained for the ventilation unit before it is installed
in Germany. This approval can be provided upon
request or can be downloaded from our website at
www.meltem.com/waermerueckgewinnung/down-
(see also the QR code on the back page of
these instructions).
The approval number is Z-51.3-138 (see item 1 in
►
For installation outside Germany, the
national regulations applicable in your
country should be followed.
1.6
Nameplate
You will find the nameplate on the intermediate
plate on the inside of the housing (see item 2 in Fig. 3).
1.7
Storage
►
Store the ventilation unit in its original packaging in a dry place where the temperature
ranges between 0 °C and +40 °C.
Fig. 3: Approval number and nameplate
1
2
