Installation manual
M-WRG-S...
- 30 -
Meltem Wärmerückgewinnung GmbH & Co. KG
Am Hartholz 4 · D-82239 Alling
[email protected] · www.meltem.com
VENTILATION THE RIGHT WAY
V E N T I L AT I O N & H E AT R E C O V E R Y
11.8
Fixing the supply air hood
WARNING
Do not run without the supply air hood.
►
Please note that the ventilation unit
must not be used without the supply air
hood. The supply air hood is designed
to prevent contact with live and rotating
parts.
►
Push the supply air hood (item 1 in
Fig. 30) into the slotted guide (item 2 in
Fig. 30). Push until you hear the latches
snap into place.
►
Use the screw (item 3 in Fig. 30) to fix the
supply air hood.
11.9
Inserting the network connection cover (on certain ventilation unit types
only)
NOTE
If a control cable was connected to the ventila-
tion unit, the network connection cover must be
inserted again. You will find the affected ventila
-
tion units in Table 4 in section 10.8 on page 22.
►
Place the network connection cover
(item 1 in Fig. 31) over the opening
(item 2 in Fig. 31) and lock it in place.
Fig. 30: Fixing the supply air hood
1
2
3
Fig. 31: Inserting the network connection cover
1
2
