Mellerware Zipp!, Manual

Page: 7 / 44

ES EN
–
–
–
–
–
–
–
–
–
–
–
–
–
–
–
–
–
–
–
We recommended vacuum
packing and sealing only one bag
per minute to allow the appliance
to recover sufficiently.
If for any reason the necessary
vacuum is not obtained, the
vacuum system will automatically
disconnect after 45 seconds. In this
case, check whether the bag has a
leak or is not properly positioned.
ONCE YOU HAVE FINISHED USING
THE APPLIANCE
Unplug the appliance from
the mains.
Put the cable back in the
cable housing.
Clean the appliance.
Cleaning
Disconnect the appliance from the
mains and allow it to cool before
undertaking any cleaning task.
Clean the equipment with a damp
cloth with a few drops of washing-
up liquid and then dry.
Do not use solvents, or products
with an acid or base pH such as
bleach, or abrasive products, for
cleaning the appliance.
Never submerge the appliance in
water or any other liquid or place it
under running water.
CLEANING THE VACUUM CHAMBER
Open the cover of the vacuum
packing machine by pressing the
two side buttons.
With a cloth or damped sponge
and soap.
TROUBLESHOOTING
IF NOTHING HAPPENS ON
PRESSURISING THE PACKING
MACHINE
Make sure the electrical cord is
properly plugged into the mains.
Check the cord and the mains
socket and make sure these are
not damaged in any way.
If you find any damage do not use
the packing machine.
THE AIR HAS NOT BEEN
COMPLETELY EXPELLED FROM
THE BAG
For correct packing the end of
the bag must remain inside the
vacuum chamber.
Check for possible dirt on the
sealing band or in the vacuum
chamber. If there is any dirt, clean
them and reposition them in their
locations.
The bag may be punctured. To
check this, seal the bag with a little
air inside, submerge it in water and
apply pressure. If bubbles form,
this means that there is a leak. Use
another bag.
Check that the cover is
completely closed.
THE BAGS OF THE PACKING
MACHINE LOSE VACUUM
AFTER SEALING
Creases, crumbs, grease or liquids
may be released from the sealed