Mellanox Technologies SX1012, User Manual

Page: 74 / 107

Rev 1.4 109 Mellanox Technologies
14. Local and National Electrical Codes
15. UL Listed and CSA Certified Power Supply Cord
16. Installation codes
17. Interconnection Of Units
18. Overcurrent Protection
19. Do Not Use the Switch as a Shelf or Work Space
This equipment should be installed in compliance with local and national electrical
codes.
For North American power connection, select a power supply cord that is UL Listed
and CSA Certified, 3 - conductor, [16 AWG], terminated with a molded plug rated at
125 V, [13 A], with a minimum length of 1.5m [six feet] but no longer than 4.5m.
For European connection, select a power supply cord that is internationally
harmonized and marked “<HAR>”, 3 - conductor, minimum 1.0 mm
2
wire, rated at
300 V, with a PVC insulated jacket. The cord must have a molded plug rated at 250 V,
10 A.
This device must be installed according to the latest version of the country national
electrical codes. For North America, equipment must be installed in accordance to the
applicable requirements in the US National Electrical Code and the Canadian Electri-
cal Code.
Cables for connecting to the unit RS232 and Ethernet Interfaces must be UL certified
type DP-1 or DP-2. (Note- when residing in non LPS circuit)
A readily accessible Listed branch circuit overcurrent protective device rated 20 A
must be incorporated in the building wiring.
Caution: Slide/rail mounted equipment is not to be used as a shelf or a work space. The
rails are not intended for sliding the unit away from the rack. It is for permanent instal-
lation at final resting place only, not used for service and maintenance