Configuring the Switch
Rev 1.4
Mellanox Technologies
22
The following is an example of the output:
2.2
Rerunning the Wizard
If you want to rerun the wizard run the following commands:
Interface mgmt0 state
Admin up: yes
Link up: yes
IP address: 192.168.10.43
Netmask: 255.255.255.0
Speed: 1000Mb/s (auto)
Duplex: full (auto)
Interface type: ethernet
Interface source: physical
MTU: 1500
HW address: 00:02:C9:11:2A:AE
Comment:
RX bytes:
1343502058
TX bytes:
313920869
RX packets: 17589211 TX packets: 992717
RX mcast packets: 0
TX discards:
0
RX discards: 0 TX errors: 0
RX errors: 0 TX overruns: 0
RX overruns: 0 TX carrier: 0
RX frame: 0 TX collisions: 0
TX queue len: 1000
sx-43 [standalone: master] > enable
sx-43 [standalone: master]# configure terminal
sx-43 [standalone: master]# configuration jump-start
