ConnectX IB Dual Port InfiniBand Adapter Cards With PCI Express x8 User’s Manual
37
Rev 1.2
Mellanox Technologies
C.2 Placing a Kapton
®
Polyimide Label
Prior to assembling the short bracket, you need to apply a Kapton
®
polyimide round label on the board’s Print Side.
Note: Check to see if the label is already installed as this label may have been installed at the factory.
Note: The label can be provided by Mellanox Technologies (P/N: MEC000821).
The following steps are instructions for placing the polyimide label:
1.Make sure your working area is ESD protected.
2. Hold the label with light pincers. See Figure 14.
Figure 13: Rotate the Bracket to Detach it From the Card
(c) Bracket Separated From Clips and Screws.
(a) Grip the Card in preparation for Detachment.
(b) Rotate the bracket toward the Component Side.
Figure 14: Hold Kapton Label With Pincers
