KEY
1. Pouring spout
2. Lid
3. Water level gauge (one on each side)
4. Indicator light
5. On/off button
6. Switch
7. Base
8. Removable limescale filter
PRIOR TO FIRST USE
Before using the kettle for the first time (or
following a long period without use), the
kettle should be boiled 3 times.
1. Read the safety instructions through
carefully.
2. Ensure that the cord is fully extended.
3. Fill the kettle with water until the water
level reaches the maximum filling level of
1.7 litres.
4. Switch on the kettle by pressing the
on/off button (5) down.
5. Pour out the water once it has boiled.
6. Repeat the process described under
points 3-5 three times.
USING THE KETTLE
1. Pour fresh water into the kettle. The kettle
must contain at least 0.5 l and no more
than 1.7 l.
2. Place the kettle on its base (7), which
should be placed on a fixed, flat surface.
3. Switch the kettle on by pressing the
on/off button (5) so that the button is
depressed towards the letter "I".
The red indicator light (4) will now light up
and the water will boil within a few minutes,
depending on the amount of water in the
kettle. If you want to interrupt the boiling,
you can do this at any time by pressing the
on/off button (5) or by lifting the kettle from
its base (7).
When the water is boiling, the kettle will
automatically switch off thanks to the
integrated thermostat. The indicator light
goes off and the on/off button returns to the
original position.
LIMESCALE FILTER
This kettle is
equipped with a
removable limescale
filter (8) that filters
larger pieces of
limescale when water
is poured from the
kettle. The filter is
located at the front by
the pouring spout.
• Make sure you remove the filter regularly
to clean any limescale deposits from it.
• Then refit the filter.
15
2.
3.
4.
5.
1.
7.
6.
8.
XB6188_IM2 18/06/04 14:34 Side 15
