16 GB/IE
Installation (Fig. A‒C)
Fill the water container
6
up to the marking
MAX (inside wall) with distilled water.
Note: For model HG05498A:
Push the LEDs
7
into the water container
6
and install it into the mounting pin
10
.
Note:
Push the supply hose
1
onto the sup-
ply nozzle
2
of pump
3
.
Put the decorative attachment and the attached
pump into the water container and lead the
power lead
5
through the recess for
HG05498A between decorative attachment
and water tank.
HG05498B, HG05498C (Fig. B and C)
Fill the water container
6
up to the marking
MAX (inside wall) with distilled water.
Install the LED
7
to the hose
9
.
Note:
You can pull them off the hose
9
for
cleaning. After cleaning, push the LEDs
7
over the hose
9
of decorative attachment
8
.
The LEDs
7
must face in the direction of the
decorative attachments
8
.
Push the supply hose
1
onto the supply noz-
zle
2
of pump
3
.
Put the attached pump
3
into the water con-
tainer
6
and lead the power lead
4
through
the back.
Your product is now ready for use.
Switching the product on / off
Plug the mains adaptor
4
into the mains. The
LEDs light up and water flows from the product.
Unplug the mains plug from the mains to turn
off the product.
Changing the water /
maintenance / cleaning / care
DANGER TO
LIFE BY ELECTRIC SHOCK!
Pull
the mains adaptor
4
out of the
socket before carrying out any work on the
product.
Always use distilled water to avoid the build up of
lime scale!
Note:
Water can be evaporated during operating,
fill the water up to “MAX” when water level fall to
“MIN”.
Note:
To avoid the build up of algae you should
clean regularly change the water and and clean the
water container
6
and decorative attachment
8
at regular intervals - at least once a week.
For HG05498A
Take this decorative attachment
8
from the
water container
6
.
Pull the supply hose
1
out of the supply
nozzle
2
.
Remove the LED from mounting pin.
Lie the decorative attachment
8
carefully
aside together with the LEDs
7
and pump
3
.
Carefully pour the water out from water
container
6
.
For HG05498B, HG05498C
Pull the supply hose
1
out of the supply
nozzle
2
.
Pull off the LEDs
7
from hose
9
.
Carefully put the pump and LEDs aside. Then
carefully pour out the water.
Clean the water container with a soft cloth (or
similar) use only water and a small amount of
detergent to clean if necessary. Clean the dec-
orative attachment
8
with a soft cloth (or simi-
lar) use only water and a small amount of
detergent to clean if necessary, alternatively
you may use a duster. For using duster, remind
to remove the water on surface with dry soft
cloth first. Duster can also use to clean the
grooving of the outer side of the product, sup-
ply hose
1
and surface of supply nozzle
2
.
Fill the water container up again to the MAX
mark (inside wall) with distilled water.
Rebuild the product again (see „Installation“).
