6
Identify the code and make a note of it following the code noting procedure
(see “PROGRAMMED CODE NOTING” section).
1
. Turn on the appliance to be programmed and select a programme.
2.
Look for your TV brand in the list of codes at the end of this booklet and make a note of the
corresponding code indicated alongside (e.g. Philips 0025). If your TV brand is not listed, apply the global
search described in
paragraph B
.
3.
Hold the selection key corresponding to the appliance whose code you are looking for (
or
) down
for five seconds until the light indicator at the top starts flashing to indicate that the remote control is
programming.
4.
Release the keys, Within 15 seconds, enter the brand code previously identified (e.g. 0025). The light
indicator flashes more quickly to indicate that the remote control is ready for the search.
5.
Point the remote control at the appliance. Press and release the
key slowly several times and stop
when the appliance goes off (you may have to press the
key dozens of times).
6.
When the appliance goes off, press the
key to confirm.
Three long flashes
indicate that the operation has been completed correctly.
Additional check
Check that some of the other functions used on your original remote control are working correctly. If the
commands function incorrectly or erratically, you have probably entered a code for a similar but different
remote control. In this case, repeat the search procedure from
point 3
.
HOW TO PROGRAMME THE REMOTE CONTROL
A
NOTE: during the search operation, the light indicator flashes more quickly. The light indicator
stops flashing and the remote control leaves the programming mode in the following cases:
• if no keys are pressed for 12 seconds
• if the code search list is completed. In this case, switch to programming mode
B
This operation may take a few minutes.
1
. Turn on the appliance to be programmed and select a programme.
2.
Hold the selection key corresponding to the appliance whose code you are looking for (
or
) down
for five seconds until the light indicator at the top starts flashing to indicate that the remote control is
programming.
3.
Release the keys. Within 15 seconds, enter the code 0000.
The light indicator flashes more quickly to indicate that the remote control is ready for the search.
4.
Point the remote control at the appliance. Press and release the
key slowly several times. Stop when
your appliance goes OFF (you may have to press the
key over a hundred times).
5.
When the appliance goes off, press the
key to confirm.
Three long flashes
indicate that the
operation has been completed correctly.
Additional check
Check that some of the other functions used on your original remote control are working correctly.
If the commands function incorrectly or erratically, you have probably entered a code for a similar but
different remote control.
In this case, repeat the search procedure from
point 2
.
GLOBAL SEARCH REMOTE CONTROL PROGRAMMING
B
istr. SPEEDY 210 SB-17 lin 12-12-2007 15:51 Pagina 6
