Use the qr-code on the side or connect to the
page and follow the instructions.
Once you have found the specific code for your device, set it in the remote control as described in the
ENTERING THE CODE DIRECTLY
chapter.
• Stand in front of the device to be controlled and make sure it is ON (not in stand-by). If necessary, switch
it on using the original remote control (if this is still working) or the buttons present on the device itself. (on
TVs they can be on the side or the top)
• On the MELICONI remote control press and hold the
button until the LED of the remote control
lights up; release.
• Pointing the remote control towards the device, PRESS AND HOLD the
ON/OFF
button and wait
for the device to switch off or that a shutdown menu appears.
•
PAY ATTENTION
, when the device turn off, IMMEDIATELY RELEASE the button.
• Three final flashes indicate that the operation has been completed successfully.
(only to be performed if you know the
specific code
to be set)
• On the MELICONI remote control press and hold the
button until the LED lights up; release.
• Immediately enter the previously identified specific code.
• Three final flashes indicate that the operation has been completed successfully.
For any future activation of the remote control, it is advisable to extract and note the code in use, operate as follows:
• On the MELICONI remote control press and hold the
button until the LED lights up; release.
• Enter the code
0010
.
• After a pause of several seconds, the LED produces four sets of flashes, spaced out,
corresponding to the code to be obtained. Count the number of flashes. Each set of flashes
corresponds to one digit in the code. Ten flashes correspond to the digit zero “0”.
(
example
code obtained =
1701)
• Make a note of the code obtained. You may need it in future.
DISPLAY CODE IN USE
If the remote control does NOT carry out the three final flashes, the setting is NOT successful; repeat the procedure.
If still unsuccessful, it means that the code is not included in the remote control, contact the ASSISTANCE.
ENTERING THE CODE DIRECTLY
VERIFY
Check that the MELICONI remote control operates your device in the main functions; if it does not,
REPEAT
the
procedure.
NOTE:
When the list of codes to be searched is over, the remote control exits the search and the LED remains off.
If after
2
attempts no results are obtained, try using the procedure described in the SMARTPHONE - TABLET - WEB
chapter or contact the ASSISTANCE.
MANUAL SEARCH
SMARTPHONE - TABLET - WEB
