30
The
MEMO
function allows us to store command sequences on a single button (called "launch button"),
that can be activated by simply pressing on it. This function was conceived to simplify the daily use
of the remote control if the users find themselves regularly repeating complex operations, that for
example, cause repeated commutation between different appliances.
The maximum number of sequences that can be stored is 85 and for each sequence you can store up
to a maximum of 31 button pressings. The launch buttons in a sequence can be all the normal buttons
on the remote control, with the exception of the
USE
,
PAGE,
LEARN
and
LIGHT
buttons.
In order to start recording:
1.
Programme an appliance selection button with one of the following codes:
8000, 8100, 8200,
8300, 8400 or 8500.
2.
For the programming, follow the instructions shown in the
FAST PROGRAMMING
paragraph on the
remote
control.
3.
In order to acquire and store the signals coming from one or more original remote controls, follow the
procedure.
The LOGIC12 has 6 completely empty codes, that can be called up as you wish and
can be fully personalised via the LEARN function up to an
overall maximum of 85 new commands.
Learn all the functions of a new remote control
not yet installed in the LOGIC12 database
B
6.
Within 10 seconds, press the button on the
original remote control and keep it pressed
down until the green light goes out and when the
“
STOP
” appears in the top part of the LCD.
After it goes off, the green light can be turned
on again and in the top part of the LCD will
appear the writing “
AGAIN
”: in this case, you
need to press the same button on the original
remote control again until the green light turns
off again.
7.
The procedure will only be successful when the
screen shows the writing “
END
”.
After it goes off, the red LED flashes three times,
confirming that the signal has been picked up.
Only then will the remote control be ready to
pick up other signals to associate with other
buttons.
5.
At this point, press the
LEARN
button together
with the button where you want to carry out the
association of the acquisition. In the top left hand
part of the screen the writing “LEARN” will
appear and, when you release the two buttons,
the green light will come on.
(e.g.
LEARN
+ 1 User
Display button)
MEMO FUNCTION
1.
Firstly, select the appliance required (press the
USE
button and then the button relative to the
appliance).
2.
Press the
USE
button for 5 seconds. The red
LED at the top starts flashing, indicating that
the remote control is at the programming stage.
On the screen in the top right hand corner, the
symbol
C
appears followed by 3 underscores.
Type in the code 999.
USE
5 SEC.
A