The functions of the buttons on the MELICONI remote control are only available if the original device is equipped with it.
Sometimes some functions of the original remote control are not directly present on the MELICONI remote control keypad.
To enable them, connect to the
page, use the on-line tool ACTIVATION OF REMOTE CONTROL and continue
until you see the list matching buttons between the original remote control and the MELICONI remote control.
If the function you want to play is matched with an number in
orange
color, operate as follows:
• On the MELICONI remote control
button.
• When the LED turn on,
without releasing the
button
, point the remote control towards the device
and enter the previously identified number corresponding to the function you want to get. (at the last digit
pressure, the remote control already transmits this function)
• Release the buttons; to match the function obtained to a MELICONI remote control button, within 30
seconds, press and hold the desired button.
• Wait three flashes indicate that storage; release the button. (the used button loses the original function
that will be called by setting again the activation code)
For any future activation of the remote control, it is advisable to extract and note the code in use, operate as follows:
• On the MELICONI remote control
button until the LED lights up; release.
• Enter the code
0010
.
• After a pause of several seconds, the LED produces four sets of flashes, spaced out,
corresponding to the code to be obtained. Count the number of flashes. Each set of flashes
corresponds to one digit in the code. Ten flashes correspond to the digit
zero “0”.
(
example
code obtained =
1701)
• Make a note of the code obtained. You may need it in future.
This function is very useful for locating in the dark which button to press to get the desired function.
Press for an instant the
button to activate the keypad light.
After about 10 seconds of non-use of the remote control the light turns off automatically.
With the illuminated keypad, when you press any other button, the light turns off momentarily and then
turns on after release.
If you want to delete the function in combination with a single button, operate as follows:
• On the MELICONI remote control
button.
• When the LED turn on,
without releasing the
button
, enter the code
1600
; release the buttons.
• Within 30 seconds, press and hold the button of which you want to delete the function; wait three flashes indicating the end
of the operation, release the button. (to recall the original function, setting again the activation code)
DELETE FUNCTION BY SINGLE BUTTON
LIGHT FUNCTION (illuminated keypad)
DISPLAY CODE IN USE
BUTTONS AND FUNCTIONS
