Using the MELICONI remote control to command 2 devices (TV and DECODER) it is often necessary to select the operating
mode before to operate on the corresponding device.
To avoid this uncomfortable and frequent operation, it is possible to combine in a single keyboard two different modes of use.
Automatically the
V+
V-
keys will control the TV, while the remaining keys will be the DECODER.
Operate as follows:
• On the MELICONI remote control press and hold the
button until the LED lights up; release.
• Enter the code
0069
.
• Three final flashes indicate that the operation has been completed successfully.
To return to operate in the two distinct mode of use, carry out the procedure using the code
0096
.
●
IF THE REMOTE CONTROL IS NEW AND YOU CAN NOT MAKE IT WORK
It is possible that the code set in the remote control is incorrect for the device that you want to control. Check that you have
carried out all the settings procedures correctly. If necessary repeat them, following all the steps indicated carefully.
Consult the website
to identify the specific code associated with your device or contact the ASSISTANCE.
●
IF THE REMOTE CONTROL IS NO LONGER ABLE TO CONTROL THE DEVICE
Disconnect the device from the electric socket and leave it without power for a few minutes; switch the device on again.
Remove the batteries from the remote control, press the
ON/OFF
button twice and insert NEW batteries.
Make sure that the remote control is pointing at the device without any obstacles between them.
When pressed (even unintentionally) one of the selection buttons, you put the remote control to command a certain type of
device.
Be sure to operate in the mode corresponding to the device to be controlled;
select the correct operating mode
the remote control resumes working.
●
IF SOME FUNCTIONS ARE NOT AVAILABLE ON THE REMOTE CONTROL
If some of the MAIN functions are not available, you are probably using an incorrect code. Find and set a more suitable code
as described in the ACTIVATION OF REMOTE CONTROL chapter.
Sometimes some functions of the original remote control are not directly present on the MELICONI remote control keypad.
To enable them, operate as described in the BUTTON AND FUNCTIONS chapter.
●
HOW TO CHECK IF THE REMOTE CONTROL SENDS INFRARED SIGNALS
The human eye is not able to detect infrared signals; use a camera (even that of the mobile phone).
Aim the infrared LED located in front of the remote control (not the red LED above) and press and hold on the remote control
the
5
button.
If you see through the camera, the LED light with short white / light blue flashes means that the remote control works and
emits infrared.
web:
e-mail:
IMPORTANT!
To obtain technical assistance, it is essential to indicate the BRAND and MODEL of the appliance you intend
to control and the name of the MELICONI remote control you are using.
ASSISTANCE
ATTENTION!
Most problems are caused by using insufficiently charged batteries.
We recommend checking and replace them as shown in the INSERTING THE BATTERIES
chapter.
TROUBLESHOOTING (F.A.Q.)
COMBINED KEYPAD
