安 装 步 骤
INSTALLATION STEPS
01
Page 3
ZOOM 65 Build Guide
Page 4
Please make sure to check if the brown or the black packaging box is undamaged. Please
check if the items listed above are not missing. If you’re missing any of the items above
please contact the store you purchased it from before proceeding ahead.
先检查外包装是否有破损,确认后打开包装盒,检查物品是否齐全。如有缺失,请联系您
购买商店的客服。
03
Once lubed, you can start to assemble the stabilizers.
润滑好后,组好卫星轴。
02
Please take out the stabilizer parts. You can holee mod the stabilizers using the provided
teflon strips 23 but it’s not necessary for the included stabilizers. We highly recommend
you to lube the wire 19 and housing 20 for optimal performance and sound. Please
refer to Youtube tutorials on how to properly lube stabilizers.
取出卫星轴 20 和钢丝 19 ,可使用我们提供的轴贴 23 来塡充轴孔内部空间,然后进行润
滑(润滑脂与润轴工具自备)。
04
Take the PORON switch foam 06 and place on the PCB 08 with the shiny side down.
Please make sure the holes lined up like shown in the photo below。
取出PCB 08 和轴下垫 06 ,放置轴下垫(无背胶)到PCB正面。