Melbourne MTC-49421, Owner'S Manual

Page: 8 / 20

8
SECTION 3:
OPERATION
First Use
Sharpening the Blade
Your plane ships with a coating of rust-inhibiting oil to ensure it arrives to
you in good condition, but this must be removed prior to use.
Disassemble the plane by loosening the lever cap thumbscrew and
removing the lever cap, blade, and adjuster assembly, taking care with
the sharp edge of the blade.
Unscrew the Front Handle completely, and remove the Toe and Mouth
Adjuster.
Using a clean rag, wipe all components to remove all but the lightest
coating of oil.
The blade is ground to the correct angle but will require sharpening
before use. The back of the blade may also benefit from final flattening.
Reassemble the plane, noting the correct orientation of the blade (bevel
facing up) and taking care not to damage the edge.
Do not over-tighten the lever cap thumbscrew – it only needs a quarter-
turn or so once the slack is taken out.
Periodically check the condition of the blade and resharpen as required.
A sharp blade is the single biggest factor in enjoying the use of your
plane, and the quality of the surface it produces.
When replacing the blade, check the bed is free from wood shavings and
any build-up of wax or oil.