User Manual for the Cliniklav
25
24
5.2 Log printer MELA
®
42 as output medium
_____________________________
If you have purchased a Cliniklav
25 with pre-installed log printer, and if you still cannot print out, then
please continue below with Section 5.2.2.
5.2.1 Connecting the log printer MELA
®
42 ________________________________________________
To connect a log printer (or another output medium) to the autoclave, you must hook up one end of the serial
data- and printer cable to the 9-pin jack on the top of the autoclave (see section 2.1, Fig. 1, pos. 3), and the
other end to the 25-pin connection jack on the rear of the printer. Securely insert the cable ends into the
jacks, and screw down the threaded connections finger-tight.
To provide power to the printer, plug the supplied power supply unit into the socket under the enclosure hood
of the Cliniklav
25. Then insert the plug (low-voltage output of the power supply unit) into the power-supply
jack on the rear of the printer.
For operation of the printer, please consult the instructions in its user manual.
5.2.2 Initialising the log printer MELA
®
42 _________________________________________________
After connecting the printer to the autoclave it must be registered with the autoclave processing unit
(initialised). Proceed as follows:
Operation
Display message
1. Switch on autoclave.
Display shows time,
pressure and
temperature.
2. Hold down "+" key and
also press "-" key.
Select "Function"
menu, submenu "Last
batch number".
3. Navigate with key '+' (
or ''-') to the submenu
"Batch output".
4. Press "Program" key,
select "Batch output,
submenu "output
medium".
5. Press "Program" again,
display shows current
status e.g. "No output
medium".
6. Press "+" (or "-") key
until display shows
"MELAprint".
Program Start-Stop
1 4 :2 7 :12
0 . 0 2 bar 2 5°C
Program Start-Stop
F u n c ti o n :
L a s t ba tc h n um b er
Program Start-Stop
F u n c ti o n
B a t c h ou t p ut
Program Start-Stop
B a t c h ou t p ut
O u t p ut me di um
Program Start-Stop
O u t p ut me di um
N o o ut p u t m ed i um
Program Start-Stop
O u t p ut me di um
M EL Ap r i n t