100
Switching on and off
•
Switching on:
Press the On/Off switch (10): The screwdriver starts. Hold the switch down
whilst operating. The LED working light (11) will light up.
•
Switching off:
As soon as the screw has been fully installed or removed, release the On/Off
switch. The screwdriving process is complete and the LED working light
goes out.
LED working light
When the machine is switched on, the LED working light (11) is lit to provide
better vision and to enable safer work in darker areas (Figure 6). The LED
working light goes out when the On/Off switch is released.
CAUTION! LED working light! Do not look directly
into the beam of light as this may result in damage
to the eyes.
10 – How to use
Electronic revolution regulation
The electronic revolution regulation can be achieved by adapting the
revolutions steplessly to the process you are using.
• A light pressure on the On/Off switch (10) = Low revolutions to undo stubborn
screws.
• Push down fully on the switch = Highest revolutions to drill with.
CAUTION! When drilling or using as a screwdriver,
avoid the motor coming to a standstill under load!
Direction of rotation, right/left (Figure 7)
The direction of rotation is determined using the “Right/Left” switch (6) above
the power switch.
5451240-Akkubohrsc_man 27.02.15 10:31 Seite 100
