44
•
Use the power tool, accessories
and tool bits etc. in accordance
with these instructions, taking into
account the working conditions and
the work to be performed.
Use of
the power tool for operations different
from those intended could result in a
hazardous situation.
Service
•
Have your power tool serviced by a
qualified repair person using only
identical replacement parts.
This
will ensure that the safety of the
power tool is maintained.
6 – Safety instructions
relating specifically to
the equipment
•
Wear suitable ear protectors.
• Use the machine for its intended
purposes only.
• When the machine is in operation,
grasp it with both hands and take a
firm stance.
• Power sockets for use out of doors
must be fitted with residual-current
safety switches.
• Never remove chippings or debris
when the machine is running.
• Before drilling in a wall, ensure that
there are no electricity wires, water or
gas pipes under the surface.
• Secure small workpieces to ensure
that they are not entrained by the drill.
• Remove the power plug before
working on the machine, during all
intervals in work, and when the
machine is not in use.
• Always keep the power cable well
away from the drilling zone.
• Turn switch to OFF before plugging
into power supply.
• Always use the machine with the
additional grip.
• Do not allow persons under 16 years
of age to use the machine.
• Observe general safety instructions
for handling power tools!
• To avoid hazards, damaged power
leads must be replaced by the
manufacturer or his customer service
representative.
7 – Installation and setting
Inserting bit
WARNING! Pull out mains plug.
Hold drill so that chuck (1) points
upwards. Lightly grease bit
shank, insert into chuck and turn
until it engages. Slide retaining bush
down as far as the stop – the bit will slip
into the locating shaft. Release the
retaining bush, which must return to its
initial position.
Removing bit
Slide back retaining sleeve (1a) and
remove the bit.
MB-5402720-Bedien-0609 12.06.2009 10:43 Uhr Seite 44
