Meinberg TCR510PCI, Operating Instructions Manual

Page: 10 / 20

10
Pulse outputs
The module TCR510PCI generates pulses at change of second (PPS) and change of
minute (PPM). The PPS signal is available with TTL (0/+5V) or RS-232 (-3..12V/
+3..12V) level, the PPM signal with TTL level only. If required, DIP-switches can be set
up to direct the pulses to a corresponding pin of the D-Sub-connector in the bracket.
Asynchronous serial port
TCR510PCI provides an asynchronous serial interface (RS-232) called COM0. The
serial port sends a Standard Meinberg Time string either once per second, once per
minute or on request with ASCII ‘?’ only. The format of this telegram is described in the
‘Technical Specifications’. The transmission speed and the framing can be set via the
PCI bus by using the shipped monitor software. Furthermore, the serial interface COM0
is used for a potential firmware update.
Connectors and LEDs in the bracket
The bracket of the board includes the BNC-
connector for the amplitude modulated time co-
des, three LEDs, a key for activating the Boots-
trap-Loader and a 9 pin D-Sub-plug.
The LEDs signal the status of the IRIG recei-
ver. The upper, red LED is switched on whene-
ver the internal timing of TCR510PCI is in hol-
dover mode. This state arises after power up and
if an error in the IRIG telegram is detected. This
LED changes state only at change of minute.The
central, green LED is switched on if the IRIG
receiver detects a correct telegram at its input. If
the below, green LED (Lock) is switched on, the
internal timing of TCR510PCI is synchronized
to the received IRIG code by a PLL (
P
hase
L ocked L oop).
Pressing the hidden key BSL is required for
activating the Bootstrap-Loader before updating
the firmware.
IRIG AM
Holdover mode
Code
Lock
BSL key
RxD
TxD
GND