6 Quick Start
6 Quick Start
When the unit is switched on, the following message appears on the display, which counts up a number of
points during the boot process:
LANTIME OS7
[7.00.006-STD]
HW Init ...
The NTP time server is then ready for operation and the display switches to the main menu where some
important status information will be displayed:
MRS: Sync to GNS
NTP: Offs. 2us
Thu, 23.01.2020
UTC 12:00:00
If the GNSS receiver has not synchronized (Refclock LED still red after 12 minutes), check the number of
visible/good satellites by pressing
↓
,
→
,
↓
from the main menu.
SV CONSTELLATION
SVs in view: 10
Good Svs : 9
Sel:09 30 29 0
At least four satellites must be found for the GNSS clock to synchronize. The antenna must have free view to
the horizon.
For first time installation enter TCP/IP address, netmask and default gateway. To get an overview of the
current configuration press F2 from main menu. Press F2 again to enter setup configuration page. Please ask
your administrator for propper TCP/IP configuration:
->Interfaces <
Global Cfg.
Services
Add Interf.
OK
Use Up and Dow
to select Port
lan0:0 #1of5
>172.100.100.10
Then select "Interfaces"
→
"Lan Port", and press the OK button 3 times. Then use the arrow keys to enter the
TCP/IP address, netmask and a default gateway if necessary.
>IPv4 Parameter
IPv6 Parameter
Link Mode
OK
> LAN Address
LAN Netmask
Gateway
OK
Set LAN Addrese
IPv4 lan0:0
->DHCP: enable
172.28.8.7
After this all further settings can be done via network interface, either by using a WEB browser or a Telnet
Session.
Default user: root
Default password: timeserver
IMS - LANTIME M1000
Date: 2nd July 2020
27