5 System Installation
5 System Installation
19 inch Rackmount
Mounting brackets and fixing screws are included in the scope of delivery of a half or full rack system. If
the system is supplied with an antenna and antenna cable, it is advisable to first mount the antenna in a
suitable location (see chapter Antenna Mounting) and lay the antenna cable. The power supply cable and the
network cable should also be available at the installation site before the system is installed. Make sure that
all necessary adapters for connecting the device are available. Make sure that the voltage is disconnected from
the power source during installation.
Rackmount - microSync
HR
For the installation of a microSync
HR
Half-Rack system in a 19-inch server rack, a special mounting bracket
is included in the scope of delivery. Use this bracket to mount your system. The bracket is attached to the
microSync
HR
enclosure at the four green dots (see figure) using the supplied Torx screws.
Figure: microSync
HR
and microSync
RX
rack mount. The screws for rack mounting are not included in the
scope of delivery.
In order to meet the specified shock and vibration requirements,
special mounting brackets are required.
microSync
Date: 22nd June 2020
31
