Manual ME-5310 Series
Revision 1.0E
Introduction
page 5
Meilhaus Electronic
Ensure that the connection cable is properly connected. It must be seated
firmly on the D-Sub connector and must be tightened with both screws,
otherwise proper operation of the board cannot be guaranteed!
1.1.2
Improper Application
PC plug-in boards for the PCIe- or PXIe-bus may not be taken into
operation outside of the PC. Never connect the devices with voltage-
carrying parts, especially not with mains voltage. As power supply for the
USB models only an authorized power adaptor may be used.
Make sure that no contact with voltage-carrying parts can happen by the
external wiring of the device. As a basic principle, all connections should
only be made or removed in a powered-down state.
1.1.3
Unforseeable Misapplications
The device is not suitable to be used as a children’s toy, in the household
or under unfavourable environmental conditions (e.g. in the open).
Appropriate precautions to avoid any unforeseeable misapplication must
be taken by the user.
1.1.4
Warning
The device was developed and produced in accordance to the EMC low-
voltage directive 73/23/EWG. When putting the device into operation,
especially with voltages greater than 42 V, please follow the appropriate
standards, installation instructions and national safety standards. Meilhaus
Electronic GmbH assumes no responsibility for damage in case of faulty
installation, operation or handling.
1.2
Package Contents
We take great care to ensure your delivery is complete. Nonetheless,
please check the list enclosed to verify the contents of your delivery. You
should find included:
64 resp. 128 channel TTL digital-I/O board for PCIe- or PXIe-bus
(depending on version).
Manual in PDF format on CD-ROM (optional as printed version).
Driver software on CD-ROM.
78
-
pin D-Sub male connector.