Meiko M-iClean H series, Operating Instructions Manual

Page: 27 / 62

27 / 62 9750359
Note
When installing non-MEIKO tables on the hood type machine, ensure that no risks
arise at the joint with the hood, such as danger of crushing or shearing.
Note
Assembly may be performed only by an authorised service technician.
Assembly must be carried out in accordance with the installation drawing.
• Machine is intended for installation in front of a wall.
– Otherwise, the machine must be secured against tipping backwards.
• Machine is intended for installation with table installation.
• Ensure the machine is level in both directions by using a spirit level.
• Compensate for an uneven floor by adjusting the feet.
• Table joints must be sealed with a detergent-resistant sealant (e.g. silicone).
• Check that the machine is stable.
Disposal of packaging materials, see page 57!
7 Commissioning
Warning
Danger of injury due to entry into a danger zone
Unauthorised persons might be in or enter the danger zone during transport, as-
sembly, commissioning, maintenance and repair work. This can lead to injuries.
• Only qualified persons should perform work at and with the machine.
• Remove unauthorised persons from the danger zone.
• Block off danger area and mark it for third parties.
• Never remove or disable safety devices on the machine.
7.1 Check prerequisites for commissioning
Caution
Material damage due to escaping steam
Small quantities of steam may escape through the dishwashing machine's hood
area. It is possible that adjacent furniture may warp.
• Protect adjacent furniture from warping.
• If possible, avoid installing the machine in an area close to furniture susceptible
to warping.
Prerequisites to be provided by the customer:
• Consistently frost free storage and installation area.
• Anti-slip floor coverings installed in the work area around the dishwashing ma-
chine.
• Electrical connection in accordance with the dimensional drawing.
• Fresh water connection in accordance with the dimensional drawing.
• Waste water connection in accordance with the dimensional drawing.
7.2 Perform commissioning
Note
Instruction and initial commissioning may be performed only by an authorised ser-
vice technician! The operator must not use the dishwashing machine before com-
pleting training.