Ju o CKM1 − CKM2 − CKM3 − EN
22
6. Operation and use
1.
Drive the vehicle in such a way to the bale that the bale is located right under the bale
grab (with the CKM3 the first bale has to be located right under the middle clamp arm).
2.
Let the bale grab sink until the front frame leans against the bale.
3.
When the frame pushes against the bale, the hydraulic system can be operated. The
rear frame moves towards the bale.
4.
Once the bale is clamped, put the hydraulic syst c i to ‘ ut ’.
Make sure that the rear frame has enough space above the ground so that it does not drag on
the ground.
5.
Lift the bale and drive the vehicle to the place of destination or to the next bale.
6.
For the second and third bale: drive again in such a way to the bale that the still empty
clamp arm hangs right above the second bale.
7.
Let the bale grab sink so that the front frame leans against the bale. Hold the bale grab
in such a way that the wheel will be pushed up. By doing so, the hydraulic circuit is
pushed under pressure the clamp arm will be closed.
8.
L t th ( s) si to th o di f oo d put th hyd u ic syst i ‘ tu ’. Lift
the bale grab up.
9.
Drive the vehicle away from the bales in reverse.
10.
The bale grab is ready to grab and move another series of bales.
Use Jumbo CKM1, 2 and 3
