HT 6550400100
ANEMOMETER KC-280ª
Pagina - 2
Display explanation
A- air speed units m/min
B- air speed units m/s
C- air speed units Km/h
D- air speed units m/h
E- air speed units m/min
F- air speed units knots
G- maximum air speed indicator
H- minimum air speed indicator
I- Average air speed indicator
J- low level battery indicator
K- cool air indicator
L- speed air value
M- sir temperature value
N- ºF
O- ºC
Instructions:
1.- unscrew the battery cover according to the direction indicated by the arrow, remove the insulation film from under the battery and
place a CR2032 button cell battery according to the polarities indicated. Then replace the cover-
2.- press the power / WC1 button on the device and the default temperature and air speed.
3.- Remove the turbine guard and place the device perpendicular to the direction of the air flow. air speed will be displayed on the top line
of the screen
4.- Adjust the air speed display. That is to say in normal state, press the SET / HOLD button to change the value to current, Maximum,
Minimum and average value. The indicated values will appear and the real-time indication will disappear.
5.- Adjust the wind speed units, in normal stat
e, press the “UNIT” button, the wind speed unit will flash, press the SET / HOLD button until
the desired unit flashes, press the “UNIT” button for a second time and exit the selection mode, the speed unit will stop fla
shing.
6.- Adjust the temperature uni
t by pressing the “UNIT” button twice consecutively, when the temperature unit flashes press the SET /
HOLD button to select the desired unit. Press the UNIT button to exit this mode.
7.-
“Hold” screen function. In normal state, press the SET / HOLD button
for 2 seconds to capture the contents of the screen, the HOLD
symbol appears on the screen. Press this button again to return to normal status.
Attention: during maintenance, if the battery does not have enough charge, the low battery indicator will appear on the screen.
8.- Visualization of ambient temperature and cold air temperature. In normal state, the ambient temperature is displayed on the line
below. Press / WCI to display the air flow temperature, the WCI symbol will appear. Press that button again and this indication will
disappear and the ambient temperature will be displayed again.
Note. The air speed must be higher than 1.34 m / s (4.8 km / h)
9.- To turn off the unit press the / WCI button for more than two seconds.
Operating Notes:
1. Do not operate the instrument without reading this manual
