Document reference MAODS301/E
USER MANUAL
Edition 4 - May 2022
SpeedSys300 ODS301 overspeed detection system
5 - 19
Programming parameters
COMMISSIONING OF A SPEEDSYS300 ODS301
5.10Programming parameters
After configuring the parameters in the SpeedSys300 software, the configuration has to be
uploaded to the SpeedSys300 ODS301 module in order for the module to apply and run
(activate) the updated configuration.
Activating a configuration on SpeedSys300 ODS301 module (that is, programming the
module) is only possible when:
•
The SpeedSys300 ODS301 module and SpeedSys300 software have been changed to
the Admin access level.
•
The SpeedSys300 ODS301 module (device) is set to its programming mode.
To upload (write) the configuration to the module:
1-
The SpeedSys300 ODS301 module must be connected to a computer running the
SpeedSys300 software and the module/software must be at the Admin access level
(see
2-
In the SpeedSys300 software, in the overall module information and controls window
(right), click the
Enter programming mode
button.
When prompted to enter the programming mode, click
OK
to continue.
Note that the overall module information and controls window (right) updates to display
Device status: Programming – safe state.
3-
In the overall module information and controls window (right), click the
Program device settings
button to program the module settings, that is, update the
configuration.
When prompted to proceed and overwrite existing parameters, click
OK
to continue.
NOTE:
Programming the module settings will overwrite all existing parameters on the
SpeedSys300 ODS301 module.
More specifically, the module is completely reconfigured using all of the
parameters configured/changed in the SpeedSys300 software.
When prompted to commit the changes, click
OK
to continue.
After the module has been updated:
•
The SpeedSys300 ODS301 module will change from the Programming – safe state
mode back to the Operating mode and run using the updated parameters.
At any stage, the programming of parameters can be cancelled by clicking the
Abort programming mode
button in the overall module information and controls window
(right).
E
NTERING
THE
PROGRAMMING
MODE
WILL
FORCE
THE
S
PEED
S
YS
300 ODS301
MODULE
AND
ITS
OUTPUTS
INTO
THEIR
SAFE
STATE
. A
CCORDINGLY
, I
T
IS
HIGHLY
RECOMMENDED
THAT
MODULE
PROGRAMMING
IS
ONLY
PERFORMED
IN
ACCORDANCE
WITH
THE
OPERATING
PROCEDURES
FOR
THE
MACHINERY
BEING
MONITORED
AND
THAT
APPROPRIATE
PRECAUTIONS
ARE
TAKEN
AT
THE
CONTROL
SYSTEM
LEVEL
(
SUCH
AS
DCS
OR
PLC).
Summary of Contents for vibro-meter SpeedSys300 ODS301
Page 118: ...THIS PAGE INTENTIONALLY LEFT BLANK...
Page 126: ...THIS PAGE INTENTIONALLY LEFT BLANK...
