CP-600DC-ID Guide
84744 Rev 2 Sept 2015
OPERATING CONTROLS
Power Switch:
The power OFF / 600 switch
turns the CT on and off.
OPERATING INSTRUCTIONS
Installation
G
Personal protective equipment
(PPE) must be used during the
installation and removal of this
instrument.
1. Connect the CT to Megger PQ device.
2. Set the power selector switch to the 600
position. Verify the ON lamp is illuminated
green. If not then change the 9V alkaline
battery in the CT.
The battery is good for up to 120 hours.
NOTE
If using this CT with a PA-9 series
power quality analyzer the PA-9
current full scale value MUST be
set to 1000.
3. View the current on the PQ Analyzer and
use the CT’s zero adjustment knob to null
out any offset.
4. Use the lever to open the jaw and place
the CT around the source to be measured.
Removal
1. Use the lever to open the jaw and remove
the CT from the source being measured.
2. Set the OFF / 600 switch to the OFF
position. Failure to do so will drain the 9V
battery in the current clamp.
3. Disconnect the CT from PQ Analyzer
MAINTENANCE
G
Have maintenance performed
only by qualified service
personnel.
Cleaning and Decontamination
Do not clean with anything more than a clean
dry cloth.
Battery Replacement
Do not change batteries while the current
clamp is installed around a conductor.
The crossed out wheeled bin placed on the
batteries is a reminder not to dispose of them
with general waste at the end of their life. This
product contains alkaline batteries located in
the NEMA housing.
They can be safely removed by removing the
screw on the back of the CT. Then replace the
9V alkaline battery and re-install the back
cover of the CT.
Spent alkaline batteries are classified as
Portable Batteries and should be disposed of in
the UK in accordance with Local Authority
requirements.
For disposal in the UK contact Megger Ltd.
For disposal of batteries in other parts of the
EU contact your local distributor.
Megger is registered in the UK as a producer
of batteries. The Registration number is
BPRN01235.
M
2621 Van Buren Ave
Norristown, PA 19403-2329
610-676-8500
www.megger.com
