3
2
1
Fig 13:
Main Unit - Connection Panel.
Item
Description
1
Power Connectors for connecting the DC Current Generator to the energy supply.
2
System Connector for connecting the DC Current Generator to the control system.
3
Emergency Stop Device physically breaks the circuit and disconnects the DC Current Generator
from the energy supply
5.3 Emergency Stop Device
The Emergency Stop Device physically breaks the circuit and disconnects the DC Current Generators from the energy
supply.
The Emergency Stop Device is located inside the Main Unit and the operating lever is mounted on the
Connection Panel. Operate only using the lever. Switch off and on is performed manually.
When the lever is switched to the ON position ‘CONNECT’, the energy supply is connected and the system can
be used normally.
To disconnect the energy supply, switch the lever to ‘DISCONNECT’.
Fig 14:
Emergency Stop Device.
CAUTION : Use the Emergency Stop Device only in case of an emergency. Excessive operation may cause
wear and damage to the contacts
5.4 Supply, Fuses and Charge Connector
1
5
2
4
3
Fig 15:
Supply, fuses and charge connector
www.megger.com
18
BALTO Compact 4000 Hardware
