megger.com
49
6 —
Setting up the Baker ZTX
NOTICE: Review all safety information provided with the equipment and presented in chapter 1 —“General
Operating Information” before setting up or operating the Baker ZTX.
NOTE: The Baker DX includes an open ground detect feature. If an open ground is detected, a banner
appears in the
Display Area
.
This circuitry should not hinder operation of GFI protected AC power circuits.
Instrument Notices
Before use:
Use the footswitch to facilitate armature bar-to-bar or span testing.
Make sure no printers are connected to the USB port.
1.
Connect the 25-pin interconnect cable to the two units. The cable is marked on each
end.
2.
Connect the footswitch to the Baker ZTX front panel connector labeled as such (not
shown in graphic).
Figure 50. Baker ZTX connections to DX and accessories.
3.
If using the remote E-stop, connect it to the indicated location on the back of the Baker
DX.
Summary of Contents for Baker DX
