4.3.9 V
ARIOUS
COMMANDS
·
CAN
(18 Hex = 24 Hex)
Cancelling the printing of previous characters.
·
ESC @
(1B 40 Hex = 27 64 Dec)
Software reboot.
All the settings are re-set to their default value.
·
GS v n
(1D 76 Hex = 29 118 Dec) ou
ESC v n
(1B 76 Hex = 27 118 Dec)
Printer interrogation on serial interface.
When receiving this sequence, the printer
sends a parameter corresponding to the n
value back on the serial interface.
No effect in parallel or USB interface.
·
ESC = n
(1B 3D Hex = 27 61 Dec)
Regrouping / Degrouping the strobes.
n = 1 (01 Hex) or '1' (31 Hex)
Regrouping the strobes
n = 0 (00 Hex) or '0' (30 Hex) Degrouping the strobes
Default value is set by the setup menu.
Degrouping the strobes:
to reduce the average power consumption of
the printer, by default, the 6 strobes driving the printing head are
successively driven one after the other. While printing text, the average
power consumption is reduced to the detriment of the printing speed.
Grouping the strobes:
to increase the printing speed, several command
strobes of the printing head can be grouped without exceeding the printers
capability. Caution: the power consumption is then at the maximum level.
·
GS <FD> <zone> <Low> <High> <datas>
(1D FD Hex=29 253 Dec) ou
ESC <FD> <zone> <Low> <High> <datas>
(1B FD Hex=27 253 Dec)
Flash memory area upload (Font, Logo, Parameters, etc...)
(This command is reserved to the factory)
Warning:
reprogramming above can not be used without consultation of our
technical services! May damage the printer !
MTH-2500, 2700 & 3500 v3.4
24
n
Parameter
0
Printer name
1
Software and version
2
Manufacturer
3
Current date and time
4
Voltage
5
Head Temperature
6
Paper Sensor
7
Printer serial number
8
EXT0 value
