3. Designations and connections
4. Application and commissioning
ENGLISH
ENGLISH
04
05
3.1 Frontside
3.2 Rear side
No.
Description
1
Power-LED
2
Port 1-8 = LAN and PoE ports (Port 1-2 = high priority)
3
Up-Link Ethernet port
No.
Description
1
EXTEND on/off (Additional switch for use with longer cable lengths up to 250 m)
2
51 V power supply
3
ground screw
1
1
3
2
2
3
Ground
power supply
Network-Video-Recorder
PoE Dome camera
PoE Dome camera
PoE Bulltet camera
PoE Bulltet camera
Note:
The transmission distance depends
on the connected cable. We recommend
standard Cat5e / 6 network cables so that
the transmission distance can be up to 100
meters!
Note 2:
The device must be connected
to the earthing in accordance with the
instructions.
For commissioning, proceed as follows:
Connection of up to 8 PoE-capable cameras
1. Switch off the power supply or disconnect the mains plug of all devices before installation. An installation
with the power turned on may damage the transmitters.
2. Connect the PoE cameras and the PoE switch to one of the Ethernet ports (port 1-8) with a network cable.
3. Connect the PoE Switch and Network Video Recorder to a network cable. Plug the cable into the uplink port
on the PoE switch.
4. Turn on the power to the devices again.
5. Verify that the installation was performed correctly and the connection is stable.
6. Make sure the PoE cameras are powered and working properly.
Note about the EXTEND switch:
1. If you set the EXTEND switch to „off“, the PoE switch will switch to normal data transmission
with a possible distance of up to 100 meters..
2. When you set the EXTEND switch to „on“, the PoE Switch enables the 10 Mbps transmission speed
at a distance of up to 250 meters.