tool storage and keep it out of the reach of children.
•
Stay alert. Focus on what you are doing, use common sense. Never use the equipment when you are
tired.
•
Check the device on a daily basis for damaged parts. If any part appears to be defective, carefully
determine if the tool is in working condition.
•
Spare parts and accessories. Use only original spare parts. Other replacement parts will void the
product warranty. Use only spare parts, which are intended for this tool.
OPERATION
LUBRICATION. It’s necessary to fill the gear cover with oil before using this pump. Fill with SAE 10 oil or
equipment lubricant up to the reference line through the lubrication bolt hole shown as below. As short lubricant
can damage the gears, test and inspect the lubrication periodically can avoid troubles occur.
DISCHARGING VOLUME. Turn the handle in clockwise direction and discharge one litre per revolution.
FILTER. 180 micro brass filter provided is located at the bottom of suction pipe. Motor revolution becomes harder
when the filter is clogged with dust. Remove the filter periodically and clean with kerosene.
CAUTION: NOT FOR WATER OR OTHER LIQUIDS THAT MAY CAUSE CORROSION.
TROUBLESHOOTING
Problem
Cause
Solution
Handle fails to turn
Dust Clogging in the Pump
Gear Breakage
Overhauling
Repair
Handle is heavy to turn
Dust Clogging in the Pump
Filter is blocking
Overhauling
Cleaning the filter
Handle turns but there
is no discharge
Gear Breakage
Shaft and Pin Breakage
Repair
Repair
CAUTION: Do not use this pump for transferring any solvent or chemical which dissolves rubber.
Do not pump any liquid containing dirt, such as waste oil.
7