9
PARTS
OPERATION
Preparations
1.
After unpacking the product, inspect carefully for any damage that may have occurred during transit. Make
sure to tighten fittings, bolts, etc. before putting unit into service.
2.
Thoroughly mix and thin paint in accordance with the paint manufacturer’s instructions. Most materials will
spray readily if thinned properly.
3.
Strain material through filter, cheese cloth or a paint strainer.
4.
Fill the canister about 3/4 full and start the air compressor.
WARNING! DO NOT EXCEED spray gun or any other parts in the compressor system MAXIMUM
PRESSURE.
5.
After connecting the gun to air supply, please make sure that the fluid cap, container and air hose have
been connected tightly with spray gun.
6.
Set up a piece of cardboard or other scrap material to use as a target and adjust for best spray pattern.
WARNING! Never aim or spray at yourself or anybody else which would cause serious injury.
7.
Test the consistency of the material by making a few strokes on a cardboard target. If material still appears
too thick, add a small amount of thinner. THIN WITH CARE! Do not exceed paint manufacturer’s thinning
recommendations.
