1.
IMPORTANT:
Turn off the mains electrical supply.
2.
Ensure that the wall (back) box has a minimum depth of 35mm.
3.
Remove and disconnect the existing light switch (if applicable). It may be
useful at this point to mark out or take a photograph of the connections to
the existing switch so that the correct wires can easily be transferred to the
new Dimmer. Some existing wiring configurations can be complex so take
care.
4.
Gently remove Dimmer faceplate by inserting a screwdriver into the
bottom slot/s and lifting away from the unit as shown.
Installation
Summary of Contents for lightwaveRF Connect Series
Page 2: ......
