6
Main Power Connection
Caution!
1.
Do not connect fixture to a dimmer system.
2.
This unit has Auto switching power supply. It will respond to 110V or 220V automatically
3.
This unit must be earthed. (electronically grounded)
4.
Replace fuse only with the specified type and rating.
The occupation of the connection
-
cable is as follows:
DMX
-
512 Connection
This fixture is equipped with an electronic power supply that will let the unit operate from 100V to 240V from 50Hz to
If you did not purchase the DMX controller 7057
-
CON
-
3 or 7057
-
CON
-
5 then this fixture will only turn off and on using
the switch on the rear of the fixture. You require a separate DMX controller to operate this fixture with DMX Signal. The
7057
-
CON
-
3 is equipped with a 3 pin In and Out Connection and the 7057
-
CON
-
5 is equipped with a 5 pin In and Out
Connection. You must specify when ordering that type of connection you require. The sockets are wired in parallel.
Only use a shielded twisted pair cable designed for RS
-
485 and 3 or 5 pin XLR plugs and connectors in order to connect
the controller with the fixture or the fixture with another.
Caution!
At the last fixture the DMX signal needs to be terminated with a terminator. Solder a 120 Ohm re-
sistor between the (
-
) and the (+) signal into a 3 or 5 pin XLR plug and plug it in to the last fixture
on the signal run. Pre
-
manufactured terminator plugs are available for purchase from your Mega
-
Lite dealer (P
-
DMXT).
Cable (USA)
Cable (EU)
Pin
110V
Black
Brown
White
Green
Light Blue
Yellow/Green
Live
Neutral
Ground
L
N
220V
L
L
L
N
110V—Connection
L
L
220V—Connection
1
2
3
2
3
1
DMX—input
DMX—output
1. Shield
2. Signal (
-
)
3. Signal (+)
5
3
4
2
1
1
2
3
4
5
4. N/A
5. N/A
Summary of Contents for Drama LED Z50 WW
Page 2: ......
