Operation
2. After software has been installed connect via USB cable (included in package). to the front of the Enlighten Splitter. Turn the
Enlighten Splitter power on. The Red LED’s on channel 1 through 4 indicate there is power present. When the Green LED are
flashing that indicated that the outputs are sending DMX signal.
2. Use the four output channels to send
DMX signal to your DMX fixture. (You
can use ether the 3 or 5 pin XLR con-
nection).
1. Upload your software into the computer. Software is located inside the USB Storage device (included in package). You can
also use this device to store your show. The most current version of the Enlighten Software can be downloaded from the Mega-
Lite website at www.mega-lite.com
or
Caution!
Do not connect a second DMX controller to the DMX input
while the Computer is connected via the USB.
6
Summary of Contents for Disco DMX-512
Page 2: ......
