User Manual for ML2000
15.08.2017
Display Unit
9
A password is required to enter the advanced settings screen. This is to prevent accidental or
unauthorized changes to your settings. The password (by default) is the number
3
.
3.4.1
Filter Configuration
Select
Menu
System Settings...
Advanced
Filter Config...
.
The filter is used to specify which organization, weapon and shooting distance that the
monitor will be used for. For example, if organization is set to ISSF then all courses of fire
and target types not related to this organization will be removed from all operating menus.
3.4.2
Target Configuration
Select
Menu
System Settings...
Advanced
Target Config
This menu is used to change the parameters for the target connected to the monitor. The first
screen shows the related parameters.
•
Sensor
Specify the sensor type that the target unit is configured to use
(Printed on the target).
•
Offset X
Specify
horizontal
offset in millimeters (mm).
•
Offset Y
Specify
vertical
offset in millimeters (mm).
•
Turned sensor
Mirrored target. Can be used if the target is positioned the opposite
way (back side).
•
Frame sensor
Specify if the frame sensor is to be used. (applicable only for targets
that support frame sensors)
•
External motor
Specify if the target has a connection to an external motor for band
advance. (applicable only for targets that support connection to an
external motor)
To change these parameters, select
Config…
. When you are finished making your changes
and have selected
Finished
, you then need to select
Send Data
to transfer your changes to the
target.
3.4.3
Set Target ID
Select
Menu
System Settings...
Advanced
Set Target ID
Select
Select ID
to set the ID for the target.
The master monitor can set target ID for all targets.
IMPORTANT:
Make sure that ONLY ONE target is connected when you set the target’s ID
otherwise all targets will receive the same ID number. They must connected and set one-at-a-
time.
