MegaLife ML-PC07AM-K5NNA2B, Owner'S Manual, Page: 12 / 34

Introduction for buttons on remote controller
4
Swing button
Not available for this unit.
Not available for this unit.
6
Sleep button
9
NOTE: There are 3 speeds for the Fan Speed of this model.
5
Fan button
This button is used for setting Fan Speed in the sequence that goes from AUTO,
, , to then back to Auto.
Auto
Speed 1 Speed 2 Speed 3
Press this button to go into the Sleep operation mode. Press it again to cancel this
function. This function is available in COOL, HEAT (Only for models with heating
function) mode to maintain the most comfortable temperature for you.
8
Health button
7
Timer button
Under ON status, press this button to set timer OFF; Under OFF status, press
this button to set timer ON.
Press this button once and the characters of HOUR ON (OFF) will flash to be
displayed. Meanwhile, press “+” button or “-” button to adjust timer setting (time
will change quickly if holding “+” or “-” button). Time setting range is 0.5~24hours.
Press this button again to confirm timer setting and the characters of HOUR ON
(OFF)will stop flashing.
If the characters are flashing but you haven’t press timer button,timer setting status
will be quit after 5s.If timer is confirmer, press this button again to cancel timer.
WiFi button
Press " WiFi " button to turn on WiFi function, " WiFi " icon will be displayed on the
remote controller;
Hold " WiFi " button for 5s to turn off WiFi function and " WiFi " icon will disappear.
Under off status, press "MODE" and " WiFi " buttons simultaneously for 1s, WiFi
module will restore factory settings.