Mega BEAM230 MJ-1016A, User Manual

Page: 10 / 14

LED Beam 230 MJ-1016A User Manual ver2.0
www.mjledlighting.com
10
7.
Press “
Encoder Pan-Tilt
” , and choose
Encoder Pan-Tilt by “ UP&DOWN
”
，
it will be show
ON/OFF , to confirm by press “ Ok
” button.
8.
Press “
No DMX Signal Mode
” , and choose
No DMX Signal by “ UP&DOWN
” ，
it will be
show KEEP/CLEAP , to confirm by press “ Ok
” button.
9. Display Power Save is screen saver . Press “ Display Power Save
” , and choose
Display
Power Save by “ UP&DOWN
” ，
it will be show ON/OFF , to confirm by press “ Ok
”
button.
10. Turn On Startup Mode is turn on the lamp when the turn on the power.Press “ Turn On
Startup Mode
” , and choose
Turn On Startup by “ UP&DOWN
” ，
it will be show ON/OFF ,
to confirm by press “
Ok
” button.
11. Load Default Mode is Mode Rest. Press “ Load Default Mode
” , and choose
Load Default by
“UP& DOWN” ，
it will be show Ok/Cancel
, to confirm bypress “
Ok
” button.

Manual
Press “
Manual
” , and choose
Manual by “ UP&DOWN
” ，
it will be show Colour Wheel,
Stop/Strobe, Dimmer, Gobo Change, Prism Insertion, Prism Rotation, Frost, Gobo Shak, Focus,
Pan, Pan Fine, Tilt, Tilt Fine, Pan-Tilt speed, Rest, Lamp Control
, to confirm by press “
OK
”
button.
1. Rest Model is the light rest
2. Colour Wheel, Stop/Strobe, Dimmer, Gobo Change, Prism Insertion, Prism Rotation,
Frost, Gobo Shak, Focus, Pan, Pan Fine, Tilt, Tilt Fine, Pan-Tilt speed
model are Press
the Ok then pressing ”UP&DWON” button, will show 001 to 255,. correcting by “ OK
”
Button.
…………………………
3. Lamp Control ,Press the OK then pressing ”UP&DWON” button, will show ON to OFF ,.
correcting by “
OK
” Button.

System
Press “
System
” , and choose by “
UP&DOWN
”
，
it will be show Software Version, Total Fixture
Hours, Partial Fixture Hours, Total Lamp Hours, Partial Lamp Hours, DMX Monitor, System
Errors
mode,

Advanced
Advanced mode is the factory mode
Maintenance:
To prolong the life of the projector, some maintenance work has to be done to ensure the optical system in good
condition. If the projector does not function, check the fuses on the power socket of the projector, they should only
be replaced by fuses of the same specification. Should these be damaged, call a qualified technician before
replacement. The projector has thermal protection device that will switch off the projector in case of overheating.
Should either of these operate, check that the fans are not blocked, and if they are dirty, clean them before
switching on the projector again. Check that the fans are operational, if not, call a qualified technician.
☆
Any maintenance work should only be carried out by qualified technicians.