Mega Lite Color Pac Spot W300, User Manual

Page: 10 / 11

11
Installation M aintenance: The operator has to make sure that the unit is operating safely and has the installations and
electronics checked by an expert every year.
The following points have to be considered during the inspection:
1) All screws used for installing the device or part of the device have to be tightly connected and must not be corroded.
2) There must not be any deformations on the housing, fixation and installation spots (ceiling, suspension, trussing).
3) The electronic power supply cables must not show any damages, material fatigue (e.g. porous cables) or sediments.
Further instructions depending on the installation spot and usage have to be adhered by a skilled installer and any
safety problems have to be removed.
Parts List
7317-MPCB Main PCB card
7317-PS Power Supply
7317-DIS Display
7317-LED LED
7317-FG Front Glass
Caution!
1. The installations must be carried out by an authorized dealer or trained professional.
2. Unit may cause severe injures if you have doubts concerning the safety do not install.
3. Unit is to be 24inches away from flammable materials (decoration material)
4. Use high quality installation equipment to hang unit.
When rigging a unit it is very important that you follow common safety procedures. Rigging requires extensive experi-
ence including but not limited to calculating working loads, material being used and periodic safety inspections. If you
lack these qualifications, do not attempt the installation yourself, instead use a professional structural rigger.
When rigging the unit always be secured with a secondary safety attachment. The installation location of the fixture has
got to be built in the way that it can hold 10 times the weight for 1 hour with out any harming. Installation should be
checked at least one time a year by a skilled person.
7317-SCR Thumb Screw Set
7310-KN Knob Set
Rigging the fixture
Cleaning and Maintenance
Accessories
7317-GH Gobo Holder (included)
7317-GR Gobo Ring (included)
7316 Color Pac 150 DMX (wireless controller)
7317-GC Gobo Clip (included)
7310-BAG 1 Unit Travel Bag
Note: There is no serviceable parts inside the device except for the fuse. Maintenance and service operations are to be
carried out by authorized dealers.
Replacing the fuse: Only replace the fuse with the same type and rating.
Replacing the power cable: If the power cable of this device becomes damaged, it has to be replaced by authorized
dealers only
Should you have further questions , please contact your dealer.
7317-BAT Battery
7310-IRC IR Controller (included)
7317-ANT Wireless Solutions Antenna