Installation and Notice
Laminate Your Value
The MEFU Laminator should be assembled and used in a clean
room with a normal room temperature and normal humidity
levels. The work place should be dry and ventilated. Do not use
this machine near water source or wet ground. This minimizes the
occurrence of static electricity. In the meanwhile, do not close to
combustible and explosive goods.
Delivery inspection
When the machine is delivered, the following units are included:
·
MEFU laminator
·
Manual
·
Accessories
Connections
Voltage: AC220/240V 50-60HZ
Electrical connectors may only be
connected to socked to sockets with the
correct voltage. All other operations may
only be performed by authorized staff.
Positioning
The MEFU Laminator should be placed in a dry and ventilated
situation.
Before use
Check the chains and gears (at a regular time), clean and lubricate.
Using
The roller is hot during working, please do not touch it,in case of scalded or
bruised.
After use
Place the roller in the idle position, raised 5 mm above the working table.
Clean the roller at a regular time, do not use water to clean the machine in
case of short circuit, electric shock or rust.
Use 80% alcohol, detergent or eraser to clean the rollers after lamination,
which can lengthen the rollers' life.
1.
The temperature of the roller should under 40
℃
and stop heating.
2.
Do not focus on one point.
3.
Clean the residuum in time, otherwise it will affect the yields.
Assembly with the steps performed by
technician authorized.
5