MEFE—Mitchell Engineering Food Equipment Pty Ltd
23 Storie Street Clontarf QLD 4019 Australia
www.mefe.com.au | [email protected]
Page 2
+617 3283 4536
Free AU 1800 669 006
General Safety Guidelines Before Using This Power Tool
•
Always wear eye protection and respirator.
•
Keep Bystanders out of the work area while operating the tool.
•
Wheel nuts and eye shields must be properly adjusted and tightened.
•
Always make sure wheels are properly mounted.
•
Stand to the side of the sharpener during start up. Switch it on and let the sharpener operate at full speed for approximate-
ly one minute so that any undetected flaws or cracks will become apparent.
•
Keep guards in place and working properly.
•
Keep hands clear of grinding wheels.
•
Never reach behind or beneath grinding wheels.
•
Disconnect power before changing grinding wheels or servicing. The grinding wheels continue to rotate after the tool is
switched off. Always allow wheels to stop before adjusting or servicing. Do not forcibly stop grinding wheel.
•
To avoid electric shock, DO NOT use in damp conditions or expose to rain.
•
When fitting a new grinding wheel, always check that the stated maximum RPM meets or exceeds the RPM stated on the
sharpener, also check the wheel for damage, such as flaws or cracks, if the wheel appears satisfactory, fit it to the machine.
•
When a new grinding wheel has been fitted, allow one minute of operation before use to check the wheel for flaws.
•
Only use accessories that are recommended by the manufacturer of your model.
•
DO NOT attempt to cut anything using the grinding wheel.
•
Grounded tools must be plugged into an outlet that has been properly installed and grounded in accordance with all local
codes and standards. Never remove the grounding prong from the plug or modify it in any way.
•
Do not use adapter plugs, if in doubt as to whether the outlet is properly grounded, consult a qualified electrician.
•
Do not use the tool when tired or under the influence of drugs, alcohol or medication.
•
Do not wear loose clothing, gloves or jewellery; tie up long hair and button all long sleeve shirts.
•
Ensure the power switch is off prior to plugging in the tool.
•
Do not over tighten spindle nuts.
•
Spacing between tool rest and wheels should be set to
1/8”
or less; hold work piece firmly against tool rest.
•
Service on these tools should only be performed by an authorized, qualified technician.
WARNING: Failure to follow these rules may result in serious personal injury!
Additional Specific Safety Rules
DO NOT operate this machine until it is completely assembled and installed according to the instructions. A machine
incorrectly assembled can cause serious injury.
OBTAIN ADVICE from your supervisor, instructor, or another qualified person if you are not thoroughly familiar with the
operation of this machine. Knowledge is safety.
FOLLOW ALL WIRING CODES and recommended electrical connections to prevent shock or electrocution.
Failure to adhere to the following could result in fragments flying off the wheel at high speeds causing serious personal
injury:
•
Always use the provided washer and nut to mount the grinding wheel on the sharpener shaft to prevent wheel
damage or accidental separation.
