Meec tools 230-007, Operating Instructions Manual

Page: 23 / 28

ENGLISH
23

Closing or replacing the dust bag can cause the inhalation of dust. Failure to follow the instructions
for this (e.g. the use of a P2 dust mask) can result in the inhalation of dust.

Do not exceed the permitted noise level when working with the machine. Always wear ear
protection.

The use of defective cables can result in electric shock.
Electrical connection

Installation and repairs to the electrical equipment must only be carried out by an authorised
electrician.

The installed electric motor is connected and ready for use.

Damage to the insulation on power cords can be a result of:
-
Chaffing if cords are fed through windows or door openings.
- Creasing from incorrect attachment or routing of the connecting cords.
- Cuts caused by driving over connecting cords.
- Insulation damage from pulling cords out of wall sockets.
- Cracking in old cord insulation.

Power cords that have been damaged in this way are dangerous and must not be used.

Check power cords at regular intervals for damage. Make sure they are not connected to the mains
when checking them.

Power cords must comply with the relevant VDE and DIN directives. Only use H05V-F marked
power cords.

This standard specifies that a type designation must be embossed on the connecting cord.

The power supply must correspond with the power supply given on the type plate.

Extension cords must have a minimum wire cross section of 1.0 mm².

The power supply must be fused with a suitable fuse.
TECHNICAL DATA
Rated voltage 230 V ~ 50 Hz
Input power 1250 W
Motor speed 28000 rpm
Vacuum connection Ø 35 mm
Hose length 2000 mm
Air flow 120 m³/h
Filter area 0.175 m²
Filter volume 5 L
Dimensions 435 x 345 x 230 mm
Weight 5.5 kg